Amaranth Lake - MATERIAL
SAFETY DATA SHEET (MSDS) |
|
Information
of the substance and of the company |
| Commercial Product |
Amaranth Lake |
| Our Code |
L01 |
| CAS NO. |
915-67-3(parent colour) |
| C.I. NO. |
16185(parent colour) |
| EINECS NO. |
212-022-2 ( parent colour) |
| Company |
Vinayak Corporation |
| Telephone No |
91-22-203 1435 (Mumbai) |
| Fax No |
91-22-205 7093 (Mumbai) |
|
|
Chemical Composition/Information On Ingradients |
| INGRADIENT |
% CONC |
CAS |
EINECS |
| lake Amaranth |
100 |
915-67-3
(parent colour) |
213-022-2
(parent colour) |
|
|
Physical and chemical properties |
| Physical State |
Solid, fine amorphous powder. |
| Colour |
Bluish red. |
| Odor |
Odorless |
| pH value |
4-6 |
| Boiling Point |
Not applicable |
| Melting Point |
No sharp melting point observed |
| Flash Point |
Not applicable
|
| Ignition Temperature |
Not applicable |
| Explosion Limit |
Not applicable |
| Vapour Pressure |
Not applicable |
| Density |
0.20 - 0.70 |
| Solubility in water |
Insoluble in water,(may be slightly soluble
in water) |
|
Stability
& Reactivity |
| Hazardous Reactions |
No information available. |
| Hazardous Decomposition Product |
No information available. |
| Chemical In Compatibility |
Strong Reducing Agents, Decolourising Agents,
Strong Acids & Alkalies |
| Condition To Avoid |
I) Heating To High Temperature
II) Storage under damp atmosphere |
| Reactivity Data |
This material is stable under condition
of normal handling and use, but sensitive to moist air. |
|
Handling
& Storage |
| Handling |
Avoid formation of dust |
| Storage |
Keep in closed container at ambient temperature
& humidity |
| Do Not Store Together |
Store Colourwise |
|
Exposure
Controls/Personal Protection |
| TLV |
No |
| Respirator Protection |
May be used (In case dust formation particle
filter e.g. DIN 3181-21 may be) |
| Ventilation |
Local ventilation capable of minimising
dust emission at the point of use |
| Eye Protection |
Protective glasses may be used |
| Hand Protection |
Rubber gloves may be used wash the hands
before and at the end of work with water, soap |
|
Hazards
Identification |
Not hazardous.
Slight risk of dust explosion |
|
First
Aid Measures |
| Eye Contact |
Wash eyes with plenty of water for at least
15 minute |
| Skin Contact |
Wash off with plenty of water & soap |
| Injestion |
plenty full water to be taken inside, special
medical attention may not be necessary |
| Inhalation |
Seek medical attention if excessive. |
|
Accidental
Release Measures |
| Clean up procedure |
Remove split powder by vaccum cleaner or
Sweeping, for disposal of waste, -see section 10 |
| Absorbent Material |
Use clean cotton cloth |
|
Disposal
Consideration |
| Can be sent to an incineration plant in accordance
with local regulations |
|
Fire
Fighting Measures |
| Extinguishing Media |
Use dry chemicals or carbon dioxide CO2 |
| Thermal Decomposition |
Dangerous decomposition is not anticipated |
|
Toxicological
Information (In Rats & Mice) |
| LD 50(rat) |
20000 mg/kg body weight |
| Eye Irritation |
Moderate irritant |
| Dermal Irritation |
Not irritating to skin. |
|
Ecological
Information |
| Water Hazard |
No information available. |
|
Transport
Information |
| Not classified as Hazardous. |
| Keep separated from hazardous chemicals |
|
Regulatory
Information |
| Manufactured as per specification set by BIS
(India), FAO/WHO (JECFA). Each country has its own laws
on colouring of food-stuffs, colourant permitted and their
purity standards |
|
Other
Information |
| This product should be stored, handled and used in accordance
with good industrial hygienic practices and in conformity
with any legal regulation. The information contained herein
is based on the present state of our knowledge and is
intended to describe our products from the point of view
of health and safety requirements. It should not therefore
be construed as guaranteeing specific properties |
|